Spindle veneer peeling machine
is one of the main equipment for the production of plywood. It is widely used in the wood industry. Like most machinery, small problems will inevitably occur after long-term use, such as large noises during operation. This is an annoying situation. The following is the editor’s analysis of the cause of noise in the operation of the spindle veneer peeler
One of the problems that the spindle veneer peeling machine
is prone to is the continuous temperature rise of the bearing and the noise of the bearing part. The reason for this problem must be determined.The rotor of the motor and the rotor of the wood flour machine are not concentric, which will make the bearing bear additional load impact and cause the bearing to overheat.
The solution to this problem: When this problem occurs during the operation of the veneer peeling machine
, the bearing must be removed in time to repair the worn part, and then reinstalled and used after the machine is turned on.
The main shaft veneer peeler
is a very important mechanical equipment in the wood industry. The performance of the veneer peeler directly affects whether the veneer peeler can work normally. Therefore, we must pay attention to the maintenance and maintenance of the machine.
Summary: When the motor rotor of the main shaft veneer peeling machine
and the wood flour machine rotor are not concentric, the bearing will be subjected to additional load impact, resulting in overheating of the bearing, which will cause the bearing to make a lot of noise during continuous heating.
Don’t take it seriously if there are minor problems in the operation of the main shaft veneer peeler. Sometimes it will directly affect the normal operation of the veneer peeler.
The above is about why the spindle veneer peeler
has noise during use and how to solve it. I hope it will be helpful to everyone. Want to know what is the function of the inverter on the veneer peeler
? What are the advantages? Friends, please continue to follow us!