Debarker is one of the main equipment for the production of plywood.It improves the production efficiency of the company.The company must do a good job in daily maintenance and maintenance during the use process,so that it can lastingly bring greater economic benefits to the company.
　Do a good job in the daily maintenance and maintenance of the debarker,and require the staff to operate the equipment in strict accordance with the operating specifications.It is strictly prohibited to operate the equipment in violation of the rules.When the machine is in an unstable state,it should be stopped and repaired in time.On this basis,a good habit of equipment maintenance and maintenance is formed.Before the machine works,check whether the machine is grounded and whether the button status is normal.Pay attention to changes in the working state of the machine at any time during the working process.If the machine generates heat or abnormal noise occurs,stop the machine in time and perform maintenance.If the thermal relay action causes a stop due to overload,you need to press the"reset"button of the thermal relay to continue the operation.After the machine is used,the machine should be regularly inspected and maintained.During the spot inspection,pay attention to check whether the oil volume of the oil cylinder is sufficient.If the oil volume is insufficient,add it in time;check whether the machine parts are worn out,and replace them immediately if they are damaged.;Also check whether the parts are loose,and adjust and tighten them in time to prevent them from falling off during work.In addition,for the rotating parts of the round machine,such as gears,bearings,shafts and sleeves,oil should be filled once a week.The oil used in the fuel tank should be replaced and cleaned every six months.The filter should be cleaned once a month.The AC contactor should be checked every six months,and the equipment should be checked and repaired once a year.When the machine is not in use for a long time,cut off the power supply,wipe the machine clean,and add lubricating oil to the parts that need to be lubricated to prevent rust.
　We hope that debarker will do a good job in daily maintenance.The maintenance of debarker equipment must adhere to the principle of equal attention to maintenance and prevention.According to the different performance and use requirements of the equipment,carry out daily overhaul,medium repair,small repair work and other emergency repairs.Try to avoid wind,sun,and bumps during the service cycle,thereby increasing unnecessary repairs and maintenance.Do a good job of maintenance at ordinary times.If minor problems arise,they must be resolved in time,so that there will be no strikes.

　Doing the debarker’s daily maintenance and maintenance work can ensure the long-term stable work of the machine,reduce the number of repairs,and extend its service life.It is also conducive to the improvement of work efficiency and quality control.Therefore,the company must do the debarker’s daily maintenance and maintenance work..