JinLun machine factory produces veneer peeling and debarker.

Contact Telephone

400-839-8077

News

Home > Debarker News

Maintenance and maintenance of the blades of the veneer peeling machine

TAG:veneer peeling machine  2021-5-2227People viewed
 In the process of using the veneer peeling machine,if you want to really play its role,the prerequisite is to understand the performance of the equipment,be familiar with the operation process of the equipment,and master the operating skills in use,so as to improve the efficiency of production.So what should be paid attention to in production to make the function of the veneer peeling machine to the extreme?
Maintenance and maintenance of the blades of the veneer peeling machine
 Firstly,before starting the equipment,check whether all parts of the machine are normal and whether there are any damaged parts.If there is a problem,replace it before using it.After the wood veneer is peeled,the wooden shaft should be removed,but it cannot be taken by hand.The maintenance of the equipment should have a good habit,small maintenance every day,and regular maintenance once to ensure that the machine can be used better..The operating skills are slowly accumulated in the course of normal use,and are also related to everyone’s operating habits.Simplifying complex things is a skill.The blade of the single-board peeling machine is very important for the single-board peeling machine.Important,it directly determines whether the product obtained by peeling the veneer meets the target expectation.The daily maintenance of the blade in daily production can reduce the wear and damage of the blade,extend the life of the blade,and the correct operation of the rotary installation of the blade can also improve Product quality and work efficiency create greater value for the company.

 The maintenance and maintenance of the blades of the veneer peeling machine should run through before use,during use,and after use.Before use,the blades must be installed correctly.The blade angle of the veneer peeler should be 30 degrees.It is fine to use a surface grinder.Because the blades of steel inserts are usually brittle,the resistance is too large and easy to break,so the feed rate can be kept at About 5 wires.The blade edge angle of the chipper is 45 degrees,and a surface grinder can be used.As long as the blade is not blue,the blade will not be annealed.When installing the blade,pay attention to whether the height of the blade is maintained at the same level and whether the nut is tightened.When in use,pay attention to whether the blade is working properly and whether it is loose,etc.,and deal with it in time if a problem is found.After use,the veneer peeler should be properly installed,and do not place it in a humid or corrosive environment,otherwise it will have an adverse effect on the blade and the veneer peeler.
veneer peeling machine
 Reasonable maintenance of the veneer peeling machine can extend their use time,and can also reduce unnecessary safety problems in the production process,thereby creating greater economic benefits for us.In the case of long-term operation,the veneer peeling machine will cause some parts to wear,some lubrication will be reduced,some parts will be loose,etc.,a series of failures will lead to inefficient work.

 Regular maintenance of the veneer peeling machine can keep the equipment in good condition and work at any time.The scope of maintenance is to reduce the load,pay attention to inspection,and strengthen lubrication,which will definitely extend the life of the veneer peeling machine and improve work efficiency.

Other News