Automatic debarker,as equipment in the wood industry,the use of automatic debarker not only improves the precision and quality of veneer production,but also improves the efficiency and automation of production.The automatic debarker is simple to use and saves energy.It is not too difficult to repair if damage occurs.If you should pay attention to some small details when using it.
　The specification of the automatic debarker before operation.Before the machine is started,we must ensure that the parts of the machine are in good condition and check that there is no looseness of the parts.Of course,the operation of the automatic debarker requires professional personnel to operate,and the user must go through strict The training and safety knowledge training are used after the assessment is passed,and the automatic debarker should not be used blindly and hastily.

　Before using the automatic debarker,check the firmness of the rotating parts.The inspection parts include:bearing seat,universal joint,fly cutter plate seat,fly cutter compression screw,sprocket,reducer,etc.Check the tightness of the chain,and swing the chain tightly up and down by 1cm.Sprockets and chains should be oiled once every shift to ensure their service life.The direction of rotation of the cutter head:facing the feed port,the cutter head rotates clockwise.If the cutter head is working,if there is a squeaking and rubbing sound,please stop the machine immediately and open the cutter head cover inspection window to troubleshoot.When the peeling is not clean,the motor cannot be started,or the knife cannot be retracted automatically,the reason is that the knife is low and the knife seam is too small.Solution:Refer to the knife adjustment diagram to adjust the knife height and knife seam.Plug in the power,the indicator light is on,but the motor cannot start.Solution:Pay attention to whether the power supply is lack of phase or the main control line is dashed.Carefully overhaul the power and control lines and the main stop button.The tool cannot be retracted automatically.It may be because the limit switch and the retract control circuit are open.Solution:Replace the travel switch and repair the circuit.
　When the automatic debarker is working,the operator must concentrate,not half-hearted,and must wear work clothes to avoid safety accidents.Some workers slack off their work or fail to follow the process,causing unnecessary accidents.If it happens,the automatic debarker should start the formal work after the machine is turned on for 1-2 minutes to confirm the correct operation of the machine.

　After the automatic debarker is used,the power must be cut off in time.In the maintenance of the equipment,the waste wood must be cleaned up in time.Do not use hard tools to clean up.You must use soft tools to clean up the garbage on the equipment so as to protect the equipment.The surface layer of the equipment can be used to prolong the service life.It is to check whether the various parts of the equipment are loose or damaged.Only when the equipment is maintained can lay the foundation for better development in the future.

　hope that our automatic debarker will bring more economic benefits to our customers.