During the use of the shaftless veneer peeler, when the wood is about to be used up, the tail board is thin and the tail board is curled due to the lack of wood. How should this phenomenon be adjusted so that it can be improved?

　The solution to a series of problems of the non-card CNC peeling machine regarding the uneven thickness of the board, the thin tail board, or the tail board roll, the knife jump, etc.?
　Uneven thickness, first use a caliper to measure whether the two ends of the wood core are the same size. If they are the same, the knife seam is not consistent. If the tail plate is thin, adjust the knife to a higher height, so that the thickness of the tail plate is 0.2MM (1.7MM plate, and the tail plate 1.5MM). The height of the tail plate reel knife is lowered so that the thickness of the tail plate differs from the required thickness by 0.2mm;

　The reason for the poor peeling of the shaftless veneer peeling machine:

　1. The numerical control box is not well adjusted.
　2. There is a quality problem with the CNC box, or the problem of natural aging after a long time.
　3. It is the problem of single roll, which is also related to a certain degree. If the single roll is not correct, this will happen to the veneer you produce.

　How to install the knife on the shaftless veneer peeler?

　With the development of science and technology, more and more people use shaftless veneer peeling machine. How does the shaftless veneer peeling machine install the knife? The following is a detailed introduction by Jinlun Machinery.

　1. Put the knife in the slot and turn the nuts at both ends.
　2. The height is set to the height of the centerline of the chuck shaft. Rotate the bolt of the top knife to fix the knife height at both ends first, and then fix the height in the middle, and gradually locate the knife at the same level.
　3. Reinforce all nuts.
　The above is about the reason for the poor peeling effect of the shaftless veneer peeling machine and how to install the knife in the shaftless veneer peeling machine. I hope the content summarized by the editor can help you! Want to know more about the advantages of the shaftless veneer peeling machine system and which manufacturer’s good friend, please click to view the related article content!