Debarker is a dedicated wood processing machine,it can process wood quickly,save a lot of labor,and improve production efficiency

　debarker also has some common failures during use:

　1.Whether the motor can run normally needs to check the power control line to ensure the normal operation of the debarker.The debarker is plugged in and the indicator light is on,but the motor cannot start.Solution:Pay attention to whether it is due to the lack of phase of the power supply or the virtual connection of the main control line.Carefully repair the power and control lines and the main stop button.

　2.The debarker automatically retracts the tool.If it fails to operate normally,shut down the machine and solve the tool-retracting inspection circuit,so that the tool-retracting problem can be handled well.The debarker needs regular maintenance and repair to improve the working efficiency of the machine.

　3.When using the debarker,the size of the knife seam can be adjusted according to your own needs,so that the bark can be removed well,otherwise the net bark will be unclean.The factor is that the knife is low and the knife seam is too small.Solution:Refer to the knife adjustment diagram to adjust the knife height and knife seam.

　4.The debarker is not clean because the knife is low and the knife slit is too small.Solution:Refer to the knife adjustment diagram to adjust the knife height and knife seam.

　5.The debarker cannot retract the tool automatically.It may be due to an open circuit in the travel switch and the retract control circuit.Solution:Replace the travel switch and repair the circuit.

　debarker has a small energy consumption,a low failure rate,and a small amount of maintenance due to its huge housing is fixed and easy to use.