As we all know,the veneer peeling machine is a common equipment for veneer production.In the wood production process,some common problems will inevitably occur.How to deal with these problems?
　In the face of uneven veneer thickness,it is recommended that the user check whether the ranging encoder is ranging or the speed encoder or electronic ruler is damaged.Solution:Adjust the fast forward frequency to 2Hz and observe whether the diameter change of the log is continuous.If there is a pause,it means that the ranging encoder is broken and needs to be replaced.If the speed of the roller is inconsistent with the actual speed,you need to replace the speed encoder.

　The veneer that is peeled from the veneer is rolled.You need to loosen the ram screws and adjusting screws at both ends,widen the knife door,and then lower the height of the knife.Loosen the ram screws and adjusting screws at both ends,widen the knife door,lower the height of the knife,and then tighten the screws,so that the problem of veneer rolling can be solved.
　The veneer peeled from the veneer is wavy:this situation is generally caused by the excessive resistance of the knife.Solution:Check whether the output current of the inverter is greater than 5A during idling.If the current exceeds 5A,the machine needs to be adjusted,and check whether the resistance caused by poor lubrication is too large.