Jinlun Machinery automatic debarker,as a mechanical equipment in the wood industry,the use of the automatic debarker not only improves the precision and quality of veneer production,but also improves the efficiency and automation of production.The fully automatic debarker is very simple to use and saves energy.It is not too difficult to repair if damage occurs.We should pay attention to the following points in use.
　Check the firmness of each component before using the fully automatic debarker.Check the components:bearing seat,universal joint,disk seat,knife holder flying screw compression,sprocket,reducer,etc.

　Chain adjustment and lubrication:Check the tightness of the chain before use,and swing the chain up and down 1cm tightly.Sprockets and chains should be oiled once every shift to ensure their service life.

　The direction of rotation of the cutter head:facing the feed port,the cutter head rotates in a clockwise direction.If the cutter head is working,if there is a squeaking and rubbing sound,please stop the machine immediately and open the inspection window on the back of the cutter head to eliminate the fault.

　If the peeling is not clean,the motor cannot be started or the knife cannot be retracted automatically,the reason is that the knife is low and the knife seam is too small.Solution:Refer to the knife adjustment diagram to adjust the knife height and knife seam.

　Plug in the power,the indicator light is on,but the motor cannot start.Solution to the problem:pay attention to whether you are lack of phase in the power supply or the main control line is dashed.Carefully overhaul the working power and control lines and the main stop button.
　Cannot retract the tool automatically.It may be because the limit switch and the retract control circuit are open.Solution:Replace the travel switch and repair the circuit.

　We don’t have to panic if these small faults occur when using the fully automatic debarker.According to the points we said,we can easily solve it.We hope that our fully automatic debarker will bring more economic benefits to our customers.